How To Wire Led Light Group

    The welding method should first find out whether the Led light set uses high voltage or low voltage. Normally, considering the safety, the light strip will be equipped with low voltage power, and then select the required LED light strip, and then check the two of every three lamp beads on the light strip. A dot and the line are welded to the dot.

    The terminal connection method is to first connect all the lamp beads in parallel with many resistors. This kind of lamp strip should be equipped with 12 volts of DC power. A socket is fine, but it can also be powered directly from a 12-volt battery pack.

    The driver wiring method firstly connects the lamp beads of the light strip in series, then equips it with a driver, inserts the two pins of the driver plug into the cores of the two leads of the light strip according to the proper polarities, and then connects the driver Plug the power plug into the 220-volt power outlet at home.